<div dir="ltr"><div>TL;DR  What does a 70cm VNA trace look like? </div><div><br></div><div><br></div><div>Howdy y&#39;all,</div><div><br></div><div>The car is in the shop, so I had some time on my hands...</div><div><br></div><div>I took a 16 cm section of 450 Ohm ladder line, shorted one end, soldered on a 32.5 cm length of wire and BOOM. I have another J Pole. </div><div><br></div><div>I tacked on a short length of RG-8x, 1.6 cm from the end, and put a female BNC on the end. Closer still!</div><div><br></div><div>I calibrated my NanoVNA for 420-450 MHz and made a trace of SWR and Resistance. I am looking to hit the 444.3 repeater.</div><div><br></div><div><img src="cid:ii_mgshqznk0" alt="Screenshot 2025-10-15 at 4.16.08\u202fPM.png" width="324" height="242"><br><br></div><div>This here is some messed up stuff. Do I have to tune to catch 50 Ohms as it goes by?</div><div><br></div><div>The SWR minimum is to the left of 444.3, so my J Pole is long. I am about to nibble away. </div><div><br></div><div>Should I expect a 25 MHz cycle like this? The middle of the cycle will be crazy SWR and terrible resistance, right? </div><div><br></div><div>Comments welcome!</div><div><br></div><div>73</div><div>Dan KJ5IZK</div><div><br></div></div>